FRONT AXLE ± Differential Carrier
26-40
Drive pinion spacer
height (A) mm
Identification colour
46.67*
1
White
47.01*
1
±
57.72*
2
±
57.08*
2
Red
NOTE
*
1
: M/T
*
2
: A/T
5. Remove the companion flange and drive pinion again.
Then, after inserting the drive pinion rear bearing inner
race into the gear carrier, use the special tool to press-fit
the oil seal.
6. Install the drive pinion assembly and companion flange
with mating marks properly aligned, and use the special
tool to hold the companion flange, and then tighten the
self-locking nut to the specified torque.
7. Measure the drive pinion rotation torque (with the oil seal)
by using the special tool.
Standard value:
Bearing division Bearing lubrication Rotation torque Nm
New None (With
anti-rust agent)
0.98 ± 1.27*
1
0.49 ± 0.69*
2
New/reused Gear oil applied 0.49 ± 0.58*
1
0.343 ± 0.441*
2
NOTE
*
1
: A/T
*
2
: M/T
8. If the drive pinion rotation torque is not within the standard
value, check the tightening torque of the companion flange
self-locking nut and the oil seal installation condition.
MB990727
186 Nm
MB990850
MB990326
To Next Page
Loading...
