REAR SUSPENSION ± Rear Suspension Assembly
34-4
REAR SUSPENSION ASSEMBLY
REMOVAL AND INSTALLATION
Caution
*: To prevent bushings from breakage, the parts indicated by * should be temporarily tightened,
and then fully tightened with the vehicle on the ground in the unladen condition.
64 Nm*
1
7
8
5
6
10
2
4
3
9
81 Nm*
101 Nm*
96 Nm*
64 Nm*
96 Nm*
96 Nm*
96 Nm*
103 ± 123 Nm*
1. Shock absorber
2. Lower arm
3. Lateral rod
4. Shock absorber installation bolt
Coil spring removal steps
4. Shock absorber installation bolt
" AA 5. Coil spring
6. Silencer sheet
7. Bump stopper
8. Lower spring pad
Upper arm removal steps
5. Coil spring
9. Rear wheel speed sensor installa-
tion bolt <Vehicles with ABS>
10. Upper arm
INSTALLATION SERVICE POINT
" AA COIL SPRING INSTALLATION
Install the coil spring so that its end with identification colour
faces upward.
To Next Page
Loading...
