ENGINE <4G9-GDI> ± Camshaft and Camshaft Oil Seal
11A-19
REMOVAL SERVICE POINT
AA" CAMSHAFT SPROCKET REMOVAL
INSTALLATION SERVICE POINTS
" AA CAMSHAFT INSTALLATION
1. Apply engine oil to journals and cams of the camshafts.
2. Install the camshafts on the cylinder head.
Caution
Be careful not to confuse the intake camshaft with
the exhaust one. There is a screw hole for the cam
position sensing cylinder mounting bolt on the
exhaust-side camshaft.
" BA BEAM CAMSHAFT CAP INSTALLATION
1. Place the camshaft dowel pin as shown in the illustration.
2. Tighten the beam camshaft cap mounting bolts to the
specified torque in the order shown in the illustration.
Tightening torque:
D : 10 ± 12 Nm
d : 21 ± 25 Nm
MB990767
MD998719
Exhaust camshaft
Screw hole
Camshaft sprocket side
Approx.
106_
Approx.
101_
Dowel pin
Intake side Exhaust side
Intake side Exhaust
side
Front of engine
28 27 31 32
20 19 23 24
12 11 15 163
8 7 5 61
14 13 9 102
22 21 17 184
30 29 25 26
To Next Page
Loading...
