BODY ± Window Glass
42-12
INSTALLATION SERVICE POINTS
" AA GLASS STOPPER/CLIP/WINDSHIELD UPPER
MOULDING/WINDSHIELD SPACER/WINDSHIELD
INSTALLATION
1. When installing new windshield, temporarily position the
windshield on the body. Make alignment marks on the
windshield and body.
2. Use isopropyl alcohol to degrease the inside of windshield
circumference, and also the body flanges.
3. Apply primer soaked in a sponge evenly to the specified
positions on the windshield and body flange.
4. Dry 3 minutes or more.
5. Install the glass stoppers and windshield spacers as shown
to prevent the inside of windshield from warp or separation.
Glass stopper and windshield spacer installation position
Glass stopper
14 mm
Ceramic line
Windshield spacer
Ceramic line
14 mm
Ceramic line
Glass
end line
Windshield
Windshield spacer
Glass
end line
25 mm
25 mm
Ceramic line
Glass end line
Ceramic line
Glass end line
Windshield
spacer
Align glass stopper end
with notch in ceramic.
Align windshield spacer
end with notch in ceramic.
Caution
(1) Be sure to apply the primer to strengthen adhesion
evenly around the entire position. Note that too
thick application weakens the adhesion.
(2) Never touch the surfaces where the primer is
applied.
6. Install the windshield upper moulding to the windshield.
To Next Page
Loading...
