BODY ± Window Glass
42-13
7. Fill a sealant gun with adhesive. Then apply the adhesive
evenly around the windshield within 30 minutes after
applying the primer.
NOTE
Cut the tip of the sealant gun nozzle into a V shape to
simplify adhesive application.
8. Install the clip to the clip stud.
9. After applying the adhesive, align the alignment marks
on the windshield and body. Then, press the windshield
gently to seat.
10. Use a spatula or the like to remove any excessive adhesive.
Then clean the surface with isopropyl alcohol. Install the
windshield moulding before the adhesive hardens.
11. Wait 30 minutes or more, and then test for water leakage.
Caution
(1) Do not move the vehicle unless necessary. If doing
so, move it very gently.
(2) When testing for water leakage, do not pinch the
end of the hose to spray the water.
10 mm
15 mm
Clip stud
Clip
To Next Page
Loading...
