BODY ± DoorBODY ± Door
42-27
REMOVAL SERVICE POINT
AA" POWER WINDOW REGULATOR AND MOTOR
ASSEMBLY REMOVAL
1. Remove the door window glass assembly installation bolts.
2. Lift up the door window glass assembly, and then install
the special tool to the window glass as shown in the
illustration to prevent the window glass falling.
Caution
If a film, etc. is attached to the door window glass,
install the special tool to the outside of window glass
in order to prevent the film peeling.
3. Remove the power window regulator and motor assembly.
INSTALLATION SERVICE POINTS
" AA REAR LOWER SASH INSTALLATION
Be sure to insert the rear lower sash to the window rear sash
(at door) securely.
" BA POWER WINDOW MOTOR ASSEMBLY/POWER
WINDOW REGULATOR ASSEMBLY
INSTALLATION
Adjust the power window motor assembly and power window
regulator assembly positions as follows:
1. Connect the power window motor assembly connector
and the power window switch connector to the wiring
harness of body side.
2. Turn on the power window switch to operate the power
window motor for 3 seconds in the direction which the
window glass closes.
3. Disconnect the power window motor assembly connector
and the power window switch connector from the wiring
harness of body side.
4. Assemble the power window motor assembly and the
power window regulator so that the arm and bracket are
positioned as shown in the illustration, and then install
the power window motor assembly.
MB990480
Power window
motor assembly
Arm
Bracket
30° or less
To Next Page
Loading...
