BODY ± DoorBODY ± Door
42-28
Caution
When installing the power window regulator, do not
set it in the window glass fully-closed position. If
installing the power window regulator in that condition,
the window glass safety mechanism will not functions
correctly.
" CA DOOR WINDOW GLASS/GLASS HOLDER/DOOR
GLASS PAD INSTALLATION
1. Install the door glass pads and glass holders to the window
glass in the positions shown.
Standard value (A): 55.0 mm
Standard value (B): 419.0 ± 421.0 mm
Standard value (C): 55.0 mm
2. Install the glass to the window regulator assembly.
Caution
Do not activate the window regulator assemble before
installing the glass as the resetting in the limit switch
is cancelled.
" DALIMIT SWITCH SETTING
1. Fully close the window glass.
NOTE
The limit switch learning operation is complete once the
window glass is fully closed.
2. Check that the limit switch operates normally.
(Refer to P.42-20.)
INSPECTION
POWER WINDOW MAIN SWITCH CONTINUITY CHECK
NOTE
Since the power window main switch uses the SWS system, check the continuity with the input signal
check method. Refer to GROUP 54B ± Troubleshooting.
B
C
Glass holders
A
To Next Page
Loading...
