EXTERIOR ± Moulding and Garnish
51-9
REMOVAL SERVICE POINT
AA" ROOF DRIP MOULDING REMOVAL
Use the special tool to lever out the moulding.
Caution
If the moulding has become warped, it should not be
reused.
AB" SIDE PROTECT MOULDING REMOVAL
1. Attach protection tape all the way along the edges of the
double-sided tape which is still adhering to the body.
2. Use a resin spatula to scrape off the double-sided tape.
3. Peel off the protection tape.
4. Wipe the body surface and clean it with a rag moistened
with isopropyl alcohol.
INSTALLATION SERVICE POINTS
"AA SIDE PROTECT MOULDING INSTALLATION
Double-sided tape affixing to the side protect
moulding (when reusing)
1. Scrape off the double-sided tape with a resin spatula or
gasket scraper.
2. Wipe off the side protect moulding adhesion surface and
clean it with a shop towel moistened with isopropyl alcohol.
3. Affix the specified double sided tape to the side protect
moulding. (Refer to P.51-8.)
Specified adhesive tape:
Double-sided tape: 5 mm width and 0.8 mm
thickness
MB990449
Protection tape
Double-sided tape
Double-sided tape
To Next Page
Loading...
