EXTERIOR ± Moulding and Garnish/Windshield Wiper and Washer
51-10
4. Remove strip paper from the pressure sensitive
double-sided tape.
NOTE
Affix double-sided tape to the end of strip paper for ease
of strip paper removal. (Refer to P.51-8.)
5. Install the side protect moulding.
NOTE
If it is hard to affix the double-sided tape in winter, heat
the application surfaces at both the vehicle body and the
side protect moulding.
Body 40 ± 60C
Side protect moulding 20 ± 30 C
Apply pressure fully to the side protect moulding.
WINDSHIELD WIPER AND WASHER
SERVICE SPECIFICATIONS
Items Standard value
Park position of windshield wiper arm and blade assembly (Distance
between wiper blade and windshield lower moulding) mm
Driver's side 20 $ 5
< L.H. drive vehicles>
30 $ 5
< R.H. drive vehicles >
Passenger's side 20 $ 5
<L.H. drive vehicles >
30 $ 5
<R.H. drive vehicles >
TROUBLESHOOTING
The windshield wiper and washer is controlled by the Smart Wiring System (SWS). For troublesshooting,
refer to GROUP 54B ± Troubleshooting.
Adhesive tape
Backing paper
To Next Page
Loading...
