EXTERIOR ± Windshield Wiper and Washer
51-12
REMOVAL SERVICE POINT
AA" WIPER MOTOR REMOVAL
1. Remove the wiper motor mounting bolts.
2. Use a flat-tipped screwdriver to separate the wiper motor
crank arm from the linkage assembly, and then remove
the wiper motor.
Caution
Because the installation angle of the crank arm and
the wiper motor has been set, do not remove them
unless it is necessary to do so. If they must be
removed, remove them only after marking their
mounting positions.
INSTALLATION SERVICE POINTS
"AA WIPER ARM AND BLADE ASSEMBLY
INSTALLATION
Install the wiper blade so that the wipers stops at the specified
stop position (standard value) as shown in the illustration.
Standard value (A): 20 ± 5 mm <L.H. drive vehicles>
30 ± 5 mm <R.H. drive vehicles>
INSPECTION
WIPER MOTOR CHECK
Disconnect the wiring harness connector, and then check the
wiper motor operation with the wiper motor remaining installed
to the body.
Wiper Motor Operation Speed
Connect a battery to the wiper motor as shown in the illustration
and check the operation speed.
Stop Position
1. Connect a battery to the wiper motor as shown in the
(A) of the illustration. While the wiper motor operates at
low speed, disconnect the battery to stop the wiper motor.
2. Connect the terminals via a jumper wire and a battery
to the wiper motor as shown in the (B) of the illustration.
After the motor starts turning at low speed, it should stop
at the automatic stop position.
Linkage
assembly
Windshield lower moulding end
A
A
Operation speed check
Low speed
High speed
Stop position check
(A) Low
speed
(B) Automatic stop
To Next Page
Loading...
