SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-50
(1) Remove the glove box.
(Refer to GROUP 52A ± Instrument Panel.)
(2) Disconnect the front passenger's air bag module 2-pin
connector (red) and instrument panel wiring harness
connector (2-pin, red).
NOTE
Once disconnected from the instrument panel wiring
harness, both electrodes of the front passenger's air
bag module short automatically. This prevents the front
passenger air bag from accidental deployment caused
by static, etc.
(3) Connect deployment harnesses longer than 6 m to
each SRS air bag adapter harness and insulate the
connections with plastic tape.
Also, connect the deployment harnesses in the other
ends to short, thereby preventing the front passenger's
air bag from accidental deployment caused by static
etc.
(4) Connect the SRS air bag adapter harness to the front
passenger's air bag module 2-pin connector and route
the deployment harnesses out of the vehicle.
(5) Close all the doors with the windows fully closed and
put a cover over the vehicle to minimize report.
Caution
The cover is required as the glass, if already
damaged, may break.
(6) Separate the deployment harnesses as far from the
vehicle as possible and connect to the terminals of
the battery removed from the vehicle. Then deploy.
Caution
1) Before deploying the air bag, see that no one
is in and near the vehicle. Also, put on safety
glasses.
2) The deployment makes the inflator of the front
passenger's air bag very hot. Before handling
the inflator, wait more than 30 minutes for
cooling.
3) If the air bag module fails to deploy although
the procedure is respected, do not go near
the module. Contact your local distributor.
Instrument panel
wiring harness
connector (2-pin, red)
Front passen-
ger's air bag
module 2-pin
connector (red)
SRS air bag
adapter harness
MB686560
Shorted
6 m or longer
Insulation
tape
Deployment harnesses
Deployment
harnesses
SRS air bag
adapter harness
MB686560
Front passenger's
air bag module 2-pin
connector (red)
Cover
Deployment
harnesses
To Next Page
Loading...
