SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-51
(7) After deployment of the front passenger's air bag
module, discard as specified in the procedure (Refer to
P.52B-60).
Side air bag module
(1) Disconnect the side air bag module wiring harness
connector (2-pin, yellow) and body wiring harness
connector (2-pin).
Caution
The side air bag modules both in the driver's and
passenger's sides should be deployed.
NOTE
Once disconnected from the side air bag wiring
harness, both electrode of the side air bag module
connector short automatically. This prevents the side
air bag from accidental deployment caused by static
etc.
(2) Prepare two wires longer than 6 m for deployment
and connect the terminals in one end to short-circuit.
This is to prevent accidental deployment caused by
static etc.
(3) Touch the vehicle's body with bare hands to discharge
static in you.
Caution
Never fail to do Step (3) in order to prevent
accidental deployment caused by static.
(4) Using pliers, cut the side air bag module connector
from the harnesses. Connect the deployment
harnesses to each harness that has been cut and
insulate the connections with plastic tape.
(5) Route the deployment harnesses out of the vehicle.
(6) Close all the doors with the windows fully closed and
put a cover over the vehicle to minimize report.
Caution
The cover is required as the glass, if already
damaged, may break.
Body wiring
harness
connector (2-pin)
Side air bag module
wiring harness
connector (2-pin, yellow)
Shorted
Deployment harnesses
6 m or longer
Deployment
harnesses
Shorted
Insulation tape
A X 0 2 4 3 A L
Cover
Deployment
harnesses
To Next Page
Loading...
