CHASSIS ELECTRICAL ± Multi-Center Display <High Grade>
54A-89
(8) When sensor checking is completed, the check results
will appear on the screen. After checking the results, press
the F1 switch to return to the self-diagnosis menu screen.
(9) If the F6 switch is pressed at the self-diagnosis menu
screen, vehicle signal checking will start.
The lighting switch condition, ignition key position, shift
lever selection (R or a position other than R) and the
power supply voltage drop will be appear on the screen.
Press the F1 switch to return to the self-diagnosis menu
screen.
If the F2 switch is pressed at the self-diagnosis menu
screen, version data self-diagnosis will be carried out,
and the check results will appear on the screen.
Press the F1 switch to return to the self-diagnosis menu
screen.
6. DIAGNOSIS RECORDING
(1) If the F6 switch is pressed at the service mode initial
screen, the diagnosis recording screen will appear.
(2) Press the F1 switch to return to the service mode initial
screen.
(3) Press the F6 switch to clear any error codes which may
still be remaining from diagnosis recording.
When this is done, the clearing confirmation screen will
appear. If it is okay to continue with the clear, press the
F5 switch. To cancel clearing, press the F6 switch.
If the F6 switch is pressed, the screen will return to the
diagnosis recording screen.
To Next Page
Loading...
