Morgana DocuMaster MFC - Service Manual 101
4. Service Procedures - Machine Adjustments and Calibration
Before you start:
• Open the rear hinged panel (See Section 4.2.4)
• Do a rear guard interlock switch test (See Section 4.5.26.1).
Step Action Information
1 Loosen the screws that attach the
rear guard interlock-switch to the
mounting bracket.
Loosen the screws just enough so
that you can move the interlock-
switch on the mounting bracket (see
Figure 4.79).
2 Adjust the position of the rear
guard interlock-sw
itch until the
result of the rear guard interlock-
switch is a pass.
(See Section 4.5.26.1).
To Next Page
Loading...
