Morgana DocuMaster MFC - Service Manual 211
6. General Procedures - The MFC Machine Configuration Wizard Description
The Skew Mode Setting
The 'Skew Mode' setting shows the skew mode status. By default, the skew mode is
set to 'Auto', In 'Auto' mode, the MFC automatically sets which pair of sensors to use.
The reference that the MFC uses is the value set in the sheet-width field in the
'Finishing' setting page on the GUI panel.
• The skew mode setting field can't be set on the 'Review & Save Settings' page.
The Stretch Trim Setting
The stretch trim setting is shown above the calibration trims t
able because it is
calibrated to only the inner pair of lead-edge sensors.
The Command Buttons
The command buttons control navigation through the MCW and make the trim
calibration settings write to the EEROM.
Command Button Information
When you have completed a calibration procedure, Click
'Finish' to write the calibration trims to the EEROM.
If you need to return to a calibration page, Click 'Back' to
move to the previous calibration page.
If you need to exit the MCW, Click 'Cancel' to close the
MCW program.
Note: If you '
Cancel' the MCW program, any trim adjustments
you made will not be written to the EEROM.
To Next Page
Loading...
