Morgana DocuMaster MFC - Service Manual 257
8. Installation Manual - Install the MFC
8.3.7 Make Some Book Samples
For instructions about how to operate the MFC (see MFC User Operating Instructions
Manual).
Step Action Information
1 Open the LOAD & SAVE setting page
and load the MFC Default Job
Template
This action sets MFC parameters to
the factory defaults.
2 Load feed bins 1 & 2 with A4
80gsm p
aper.
Portrait orientation.
3 Set the MFC to feed 5
INNER
SHEETS and 1 BOTTOM INSERT and
to crease
COVER ONLY.
4 Make some books.
5 Set the MFC to feed 11
INNER
SHEETS and 1 BOTTOM INSERT and
to crease COVER ONLY.
6 Make some books.
8.3.8 Check the Book Quality
Step Action Information
1 Check the sample books for quality
of the crease, st
aple, fold, trim and
spine form.
If the quality of the books is bad,
correct the cause of the problem.
The MFC must make books of a good quality before
you can process live jobs.
To Next Page
Loading...
