Morgana DocuMaster MFC - Page 67

Morgana DocuMaster MFC - Service Manual 59
4. Service Procedures - Diagnostic Procedures
4
4 Do a check that the split pin that
locks the feed clutch to the feed
shaft is not broken.
• Replace the split pin if it is
broken.
5 Do a check that the feed clutch
output LED is on when you press
the red button on the
• Replace the feed bin control
PCB if the clutch output LED is
not on (see Section 4.8.7) or
(see Section 4.9.3).
6 Do a check that the feed clutch
cable is connected to the feed bin
control PCB correctly.
• Connect the feed clutch cable if it
is disconnected.
• Replace the feed clutch if it still
does not operate
(see Section
4.8.3) or (see Section 4.9.2).
Step Action Information