Accessory Setup: (cont’d)
Edit Accessory
Accessory Path
If you change the TIU or AIU a particular accessory is wired to (for instance if you add
TIUs and AIUs as a layout expands), you must tell the DCS system its new path. The
DCS System will activate whichever accessory is wired into the path listed, whether it is
the original accessory or not.
1. Wire the accessory into the new AIU port.
2. Follow the System Menu to Accessory Path, so that the complete list of accessories
(for all TIUs and AIUs) appears on the LCD. Scroll to the one you want to re-path and
press the thumbwheel to select.
3. Select which TIU the accessory is added to.
4. Select which AIU the accessory is added to.
5. Select the AIU port (ACC1-ACC10) the accessory is wired into.
Delete Accessory
1. Scroll until the arrow points to the accessory you want to delete and press the thumb-
wheel to select it.
2. At the LCD prompt press the thumbwheel to confirm.
DCS Command System User’s Guide
Menu Operations - Systems
71
To Next Page
Loading...
