3 Before using VJ-1624 OPERATION MANUAL
3-4
WARNING
• Do not pull out or insert the power plug with a wet hand.
This could lead to an electric shock.
• Make sure to use only the specified power supply (AC 100 V to 120 V or AC 220
V to 240 V).
If a power supply other than the specified voltage is used, it could cause an
electric shock and fire.
• Take power for the printer directly from the power socket (AC 100 V - 120 V or AC
220 V - 240 V).
Do not use multiple plugs on the same socket.
This could generate heat and might cause fire.
• Be sure to use a dedicated power socket with earth wire for the power supply,
and connect it to the earth wire.
If the earth wire is not connected, an electric shock or fire may occur.
• Do not connect an earth wire to the following places.
• Gas pipes
There is a possibility of ignition and explosion.
• Earth wire of telephone cables and lightning rods
Heavy current might flow whenever lightning strikes.
• Water pipe and faucet
The earth might not work if a plastic pipe is connected in the middle of the
metal pipe.
CAUTION
• Pay attention to the following points when handling the power supply plug.
Any mishandling of the power cable could cause a fire.
• Make sure that no foreign substances such as dust etc. are stuck to the power
plug.
• Make sure that the power plug is firmly inserted to the edge of the power
socket.
• When you do not use the printer for a long period, make sure to pull out the
power plug from the power socket for safety.
• Make sure to connect an earth wire to the earth connection that meets the
following standards.
• Earth terminal of power socket
• Earth wire with copper plate which is buried at 650 mm or more, deep in the
ground.
To Next Page
Loading...
Need help?
General