4 Handling the printer VJ-1624 OPERATION MANUAL
4-12
• When the Confirm Print is complete, the printer enters Normal.
d. After the confirmation adjustment printing, cut the media.
4.4.3 Cutting media
6. Measure the distance between the two pluses in the confirmation adjustment print using a ruler. Then,
confirm that the distance matches the feeding length when printing.
a. If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and
readjust.
b. If the distance matches the feeding length, proceed to step 7.
7. Perform Micro adjustment printing.
a. Display the Dist.Adj menu on the operation panel in the same way as in step 1.
b. Press the [+] key or [–] key on the operation panel to select "PF4: Micro Print".
c. Press the [Enter] key on the operation panel.
• "Warming Up" and "Skip ->ENTER" are repeatedly displayed on the operation panel.
d. Wait till warming up process is complete, or press the [Enter] key on the operation panel to shift
to the next operation.
• "Printing" is displayed on the operation panel.
• Starts micro adjustment printing.
No. Name
1 FeedLength
2 Media feeding direction
2
1
1
To Next Page
Loading...
Need help?
General