1. Press and hold SELECT to enter Select mode. You can also press SELECT + CONTROL to
pin this mode and make it permanent.
2. Press F1 (QUIET) to select Sounds and Groups.
→
You are ready to select more than one Sound or Group.
Selecting Sounds and Groups via the Select mode.
You have following selection tools at your disposal:
Selection Tool
Description
Pads Press any pad to set the focus to that particular Sound slot. The pad
lights up to indicate that the Sound slot is focused (and selected).
Unlit pads indicate unselected, empty Sound slots, and half-lit pads
indicate unselected Sounds. The selection behavior depends on the
state of the MULTI option (F3, see below).
GROUP then pads Press GROUP, then any pad 9–16 to set the focus to that particular
Group in the current Group bank. The pad lights up to indicate that
the Group is focused (and selected). Unlit pads 9–16 cannot be
pressed (they don’t correspond to any existing Group), and half-lit
pads indicate unselected Groups. The selection behavior depends on
the state of the MULTI option (F3, see below).
Left/Right Arrow
buttons (< BANK >)
Selects the previous/next Group bank, respectively.
F3 (MULTI) Enables/disables the multiple selection mode. Toggling this button
does nothing to the current focus nor selection but changes the
behavior of the selection process — see below.
The MULTI option (F3) switches between single and multiple selection:
Managing Sounds, Groups, and Your Project
Overview of the Sounds, Groups, and Master
MASCHINE MIKRO - Manual - 172
To Next Page
Loading...
