Furthermore, If you have selected an external signal (EXT. STER. or EXT. MONO selected in
SOURCE), an additional MONITOR section is available by pressing NAV + Right Arrow button.
In this section, You can set MONITOR to ON in order to send the input signal to the Cue bus of
MASCHINE, allowing you to hear on a separate channel (e.g., your headphones) the audio
source that is about to be recorded.
For more information on how to use the Cue bus, please refer to section ↑9.2.6, Using
the Cue Bus.
14.2.3 Arming, Starting, and Stopping the Recording
The Start and Cancel buttons.
►
Click Start to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE selector, see section ↑14.2.2, Selecting the Source and the Recording
Mode above):
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then the Start button reads a flashing
Waiting label and the Waiting for the next bar… message appears in the information
bar above the waveform display.
◦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section ↑14.2.2, Selecting the Source and the Recording Mode
above). You can also click Stop beforehand to stop the recording at the next bar, or
Cancel to cancel the recording (in that case the recorded audio will not be saved).
▪ When recording in Detect mode:
Sampling and Sample Mapping
Recording a Sample
MASCHINE MIKRO - Manual - 766
To Next Page
Loading...
