3. Turn the Control encoder to select the desired Link group 1–8 for that pad or choose
NONE (default setting) to remove the pad from its current Link group.
4. Press the Right Arrow button to display the 4/6: LINK MODE parameter.
5. Turn the Control encoder to select the desired Link mode from MASTER (default setting)
or SLAVE for that pad.
6. Release PAD MODE (or press it again if you pinned the mode).
5.2 Adjusting the Key, Choke, and Link Parameters for Multiple Sounds
In the software, if you select multiple Sounds with different Key, Choke and/or Link values, the
corresponding parameters in Pad view now display MULTI. On your controller in Pad Mode, the
corresponding parameters now display (MULTI).
Moreover, you can adjust these parameters for the selected Sounds as described below.
For general information on the Pad view of the software, the Pad Mode on your control-
ler, and the Key, Choke, and Link parameters, please refer to section 5.1 “Adjusting
Your Pads” in the MASCHINE 2.0 Manual.
Adjusting the Key Parameter for Multiple Sounds with different Key Values
►
Click and drag the MULTI label next to Key to transpose the base key of all selected
Sounds. While dragging, the field displays a +/-x value indicating the transposition that
will apply to all Sounds as you release the mouse button.
Playing on Your Controller
Adjusting the Key, Choke, and Link Parameters for Multiple Sounds
MASCHINE MIKRO - Manual - 229
To Next Page
Loading...
