1. To select the parameters described in the following sections, press the Left/Right Arrow
buttons.
2. To adjust the selected parameter, turn the Control encoder (for continuous parameters,
press and turn the Control encoder to adjust the value in finer increments).
14.2.2 Selecting the Source and the Recording Mode
At the bottom of the Record page, the parameters in the RECORDING section allow you to ad-
just which source should be recorded and how the recording should start and stop.
Adjusting the source and mode of the recording in the software.
Selecting the Source to Record
►
Click the SOURCE selector on the left to select the type of source you want to record:
▪
To record external audio signals connected to your audio interface, select Ext. Ster. (for
stereo signals) or Ext. Mono (for mono signals).
▪ To record audio signals coming from MASCHINE itself, select Internal.
►
Click the INPUT selector to choose between the available inputs:
▪
If SOURCE is set to Ext. Ster., you can select either of MASCHINE’s four external stereo
inputs In 1–4.
▪ If SOURCE is set to Ext. Mono, you can select either of MASCHINE’s eight external mono
inputs: the left (“L”) or right (“R”) channel of each input pair In 1–4.
▪ If SOURCE is set to Internal, you can select the output of any available Group or the Mas-
ter.
You can easily record the output of a particular Sound by setting SOURCE to Internal,
soloing this Sound and selecting its parent Group in the INPUT selector!
Sampling and Sample Mapping
Recording a Sample
MASCHINE MIKRO - Manual - 761
To Next Page
Loading...
