Parameter Description
ENGINE Section (Detect mode only)
ZERO-X (Zero
Crossing, Detect mode
only)
When MODE is set to DETECT, activate ZERO-X to force the detected
Slices to be created on the closest locations where the audio signal
crosses the zero value. This can be helpful to avoid clicks when
playing back Slices in another sequence.
14.4.3 Live Slicing
Live Slicing is a quick and intuitive way to add slices to a sample using the pads on your con-
troller. The first pad is used to trigger the sample and the subsequent pads are used to add
slice points as required. If necessary, the start and end points of the slices can then be fine-
tuned using Edit mode.
Live Slicing is only available from your MASCHINE controller.
14.4.3.1 Live Slicing Using MASCHINE MIKRO
To manually add Slices to a sample using the pads on your controller:
1. Press the SAMPLING button to enter the Sampling page.
2. Press NAV and turn the Control encoder to select SLICE.
3. Press an Arrow button below the display screen to select Manual mode.
⇨ Pad 1 will begin to flash to indicate that the first Slice can be added.
4. Press Pad 1 to add the first Slice to the sample.
⇨ Playback of the sample will begin and the next pad will begin to flash to indicate that the
next slice point can be added.
5. Press Pad 2 to add the second slice point.
6. Continue to press subsequent pads as they flash to add more slices.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE MIKRO - Manual - 796
To Next Page
Loading...
