Native Instruments Maschine MIKRO - Swing also Applied to Note Repeat; Arp Output

To reproduce a Note Repeat using Arp mode, set TYPE to CHORD, SEQUENCE to OFF,
and OCTAVES to 1. To repeat single notes, additionally make sure that chords are disa-
bled (in Pad Mode, check that Chord MODE is set to OFF).
5.5.5 Swing Also Applied to Note Repeat / Arp Output
The Swing engines (at the Master, Group, and Sound level) process notes coming from the Pat-
tern Editor and from the Arp engine (pads in Keyboard mode) or Note Repeat engine (pads in
Group mode). In other terms, the swing is applied not only to your Patterns but also to any live
sequence generated by the Arp or Note Repeat engine.
The applied swing is not recorded in the Pattern Editor. For an overview of the signal
flow starting from your pads, have a look at the diagrams in section ↑5.5.1, Overview of
the Perform Features.
For example, when you play live beats on top of a running Pattern, you can use Note Repeat
without destroying the Pattern’s groove: the repeated notes will be processed using the same
swing parameters as the playing Pattern.
When the playback is not running, the swing is still applied to the output of Arp (Key-
board mode) or Note Repeat (Group mode). If you press PLAY on your controller, the
playback starts immediately and the swing cycle is reset.
Playing on Your Controller
Performance Features
MASCHINE MIKRO - Manual - 259