▪ References to keys on your computer’s keyboard you’ll find put in square brackets (e.g.,
“Press [Shift] + [Enter]”).
►
Single instructions are introduced by this play button type arrow.
→
Results of actions are introduced by this smaller arrow.
Naming Convention
Throughout the documentation we will refer to MASCHINE controller (or just controller) as the
hardware controller and MASCHINE software as the software installed on your computer.
The term “effect” will sometimes be abbreviated as “FX” when referring to elements in the MA-
SCHINE software and hardware. These terms have the same meaning.
Button Combinations and Shortcuts on Your Controller
Most instructions will use the “+” sign to indicate buttons (or buttons and pads) that must be
pressed simultaneously, starting with the button indicated first. E.g., an instruction such as:
“Press SHIFT + PLAY”
means:
1. Press and hold SHIFT.
2. While holding SHIFT, press PLAY and release it.
3. Release SHIFT.
1.3 New Features in MASCHINE 2.6.5
The following new features have been added to MASCHINE 2.6.5:
Ideas View
Ideas View has been added to MASCHINE which provides an overview of the Patterns and
Scenes in the current Project similar to the grid layout of the MASCHINE JAM controller.
Scenes and Patterns can be created and combined in this view without affecting the current
arrangement. Select the Scene to edit by clicking a Scene button at the top of the grid, then
Welcome to MASCHINE
New Features in MASCHINE 2.6.5
MASCHINE MIKRO - Manual - 26
To Next Page
Loading...
