Native Instruments Maschine MIKRO - Controller Menu in the Hardware Page of the Preferences Panel

2.6.8 Controller Menu in the Hardware Page of the Preferences Panel
In previous MASCHINE versions you could have only one device focused on a particular MA-
SCHINE instance, and the Hardware page of the Preferences panel showed the settings for
that particular controller. With the integration of the KOMPLETE KONTROL S-SERIES key-
boards in MASCHINE 2.2, you can have two devices simultaneously focused on a MASCHINE
instance: a controller from the MASCHINE family and a KOMPLETE KONTROL S-SERIES key-
board.
For this reason, the Hardware page of the Preferences panel provides you with a new Controller
menu at the top allowing you to select the device of which you want to see and modify the set-
tings:
The Controller menu allows you to display the settings for the desired device.
This menu can hold up to two entries, depending on the device(s) focused on that MASCHINE
instance:
▪ No device focused on that instance: The Controller menu is empty and all settings in the
Hardware page are grayed out and inactive. To modify the settings of a device from that
MASCHINE instance, the device must be connected to your computer and focused on that
instance.
Basic Concepts
Preferences
MASCHINE MIKRO - Manual - 90