8.1.4 Configuring the Master and Cue Outputs of MASCHINE
All channels routed to the Master are mixed together and processed by the Plug-ins loaded in
the Master, if any. The result is then sent to the Master output (that is, MASCHINE’s main out-
put).
Besides, all channels currently routed to the Cue bus for pre-listening are mixed together and
sent to the Cue output.
For more information on how to use the Cue bus, see section ↑9.2.6, Using the Cue
Bus.
You can choose to which outputs (on your audio interface or in your host) both Master and Cue
outputs should be sent, and adjust their respective levels and panoramic positions. This is
done on the Audio page of the Output properties for the Master.
The Audio page of the Output properties for the Master in the software.
The AUDIO page of the Output properties for the Master on the controller.
Please refer to section ↑2.3.4, Navigating Channel Properties, Plug-ins, and Parameter
Pages in the Control Area to know how to access the Audio page of the Output proper-
ties in the software and from your controller.
Audio Routing, Remote Control, and Macro Controls
Audio Routing in MASCHINE
MASCHINE MIKRO - Manual - 425
To Next Page
Loading...
