3. In the same Link section click the Mode value (Master or Slave) to switch the Sound be-
tween Master (default setting) and Slave mode.
A Link group makes sense only if more than one pad/Sound are assigned to it!
Adjusting the Link Parameter for Multiple Sounds with different Link Values
►
Click the MULTI label next to Link and select the desired value from the list to set all
selected Sounds to that same Link group. This also applies to the Master/Slave setting
next to it.
Sound slots 1 to 4 are selected. If they have different Choke values, a MULTI label appears (left). When you click it and
select a new Choke or Link group from the list (middle), this new group is applied to all selected Sounds.
This is also true when adjusting the parameter from your controller.
To assign the selected pad(s) / Sound slot(s) to a Link group and set its/their Link mode on
your controller:
1. Hold the PAD MODE button to enter Pad Mode (or press PAD MODE + CONTROL to pin
it).
2. Use the Left/Right Arrow buttons to display the 3/6: LINK GROUP parameter.
Playing on Your Controller
Adjusting Your Pads
MASCHINE MIKRO - Manual - 228
To Next Page
Loading...
