Element Description
LOCK (F3) Keeps the Arp feature enabled even when you leave Arp mode. For
example, this can be useful to adjust the chord settings, switch to
another Pattern, adjust Plug-in parameters, etc., while keeping
arpeggios running. If Arp is locked, when you switch to another
controller mode the NOTE REPEAT button stays dimly lit to remind
you that Arp is on.
F1–F2 Selects between four different presets — also while playing. By
default F1 and F2 select the 1st and 2nd preset, respectively. To
switch to the 3rd and 4th presets, press SHIFT + F3 (>>). To switch
back to the first two presets, press SHIFT + F3 (<<) again.
Each preset can store particular values for the TYPE; RATE, UNIT,
SEQUENCE, and OCTAVES parameters (see below). The rate
currently assigned to each button is indicated below on the display
along with the UNIT value (“T” for triplet values or “D” for dotted
values). The selected preset is highlighted.
TYPE Sets the sequential order of the arpeggiated notes. You can choose
from following settings:
UP starts from the root note and plays the notes up through the
chord.
DOWN plays the notes the other way around.
UP-DOWN plays the notes in both directions alternatively.
PLAYED plays the notes in the order you pressed down the
corresponding pads on your controller. If you have configured chords,
the arpeggio will first play all notes of the chord triggered by the first
pad you pressed, then all notes of the chord triggered by the second
pad you pressed, etc.
CHORD plays all notes of the chord together repeatedly.
RATE
Adjusts the note length, hence the rate of the arpeggio. Available
values are 1 BAR and a series of note values going from 1/2 (half
note) until 1/128 (a hundred twenty-eighth note).
Playing on Your Controller
Performance Features
MASCHINE MIKRO - Manual - 257
To Next Page
Loading...
Need help?
General
