A typical 4/4 line in Step mode.
In Step mode events are created with following settings:
▪ The event pitch is set to the Sound’s base key. To know how to change the base key of your
Sounds, see section ↑5.1.3, Adjusting the Base Key.
▪ The event velocity is defined by how hard you hit the pads, unless you have enabled the
Fixed Velocity option (see below).
▪ The event length is set to one step (hence, it depends on the current Step Grid settings).
▪ Obviously, the event position is defined by the pad you hit.
Working with Patterns
Recording Patterns with the Step Sequencer
MASCHINE MIKRO - Manual - 337
To Next Page
Loading...
