Parameter Description
LENGTH (Stretch
Length, Beat mode
with Auto Detection
enabled only)
If AUTO DTCT is enabled, you can define the length of the target
audio (in bars). Please note that any change to the SRC BPM value
(see above) will be automatically mirrored by this LENGTH value. Once
you have set the number of bars in the source audio, you can set here
another number of bars, thereby dividing or multiplying the tempo of
the target audio. Available values are 1/16, 1/8, 1/4, 1/2, 1, 2, 4, and
8 bars, as well as the corresponding triplet values.
SPEED
(Free mode only)
Adjusts the new tempo relative to the original tempo (in percentage).
The minimum value is 10 %.
In Beat mode, if you set a target tempo that is smaller than a tenth of the original tem-
po, the Apply button will be disabled. Set a higher target tempo to enable the Apply but-
ton again!
â–º
Once you have set the parameters to the desired values, click Apply to apply the pitch
shifting and/or time stretching to the selected region in the Sample, or Cancel to let the
Sample untouched.
Audio Editing Functions on the Controller
The EDIT page additionally provides several audio editing functions to process your Sample.
Audio editing functions at the top of the display on the controller.
1. Use F1 and F3 to select the desired audio function.
2. Press F2 to perform the selected audio function.
Sampling and Sample Mapping
Editing a Sample
MASCHINE MIKRO - Manual - 784
To Next Page
Loading...
Need help?
General
