Native Instruments Maschine MIKRO User Manual

Editing Your Zones on Your Controller
At the bottom of the left display, the Zone settings allow you to adjust how each Zone should
be played back.
The various parameters always display the values for the focused Zone.
The parameters available in the Zone settings are spread over five pages.
►
Use the Page buttons on the left of the displays to select the desired page.
Page 1 – PLAY RANGE Parameters
The parameters in the PLAY RANGE page allow you to adjust the portion of Sample that will
be played back when the Zone is triggered.
Parameter
Description
START (Knob 1) Adjusts the playback’s start point in the Sample of the focused Zone.
END (Knob 2) Adjusts the playback’s end point in the Sample of the focused Zone.
►
Hold SHIFT when turning the Knobs to adjust the parameters in finer increments.
In the waveform on the right display, the regions outside the play range are grayed out.
Page 2 – LOOP Parameters
The parameters in the LOOP page allow you to define and adjust a portion that will play in loop
while the note is held.
Parameter Description
ACTIVE (Knob 1) Enable this to define a loop in the Sample of the focused Zone.
When the play position reaches the loop, the playback is looped as
long as the note is held. This can be useful to loop either a whole
Sample or part of it, e.g., to simulate a longer tone. Note: this
technique requires that you set the Sampler’s TYPE selector to AHD
or ADSR in the PITCH / GATE section (Parameter page 2, see
↑6.2.2, Page 2: Pitch / Envelope).
START (Knob 2) Adjusts the start point of the loop.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE MIKRO - Manual - 826

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English