Native Instruments Maschine MIKRO User Manual

Press and turn the Control encoder to adjust the parameters in finer increments.
In the waveform on the display, the regions outside the play range are grayed out.
Page 2 – LOOP Parameters
The parameters in the LOOP page allow you to define and adjust a portion that will play in loop
while the note is held.
The ZONE page on the controller, page 2 of 5: LOOP parameters.
Parameter
Description
ACTIVE Enable this to define a loop in the Sample of the focused Zone.
When the play position reaches the loop, the playback is looped as
long as the note is held. This can be useful to loop either a whole
Sample or part of it, e.g., to simulate a longer tone. Note: this
technique requires that you set the Sampler’s TYPE selector to AHD
or ADSR in the PITCH / GATE section (Parameter page 2, see
↑6.2.2, Page 2: Pitch / Envelope).
START Adjusts the start point of the loop.
END Adjusts the end point of the loop.
XFADE Allows you to blend a little of the material near the loop start and
end points in order to get a smoother, less abrupt loop. This is
particularly helpful if the loop is inducing any clicks.
Press and turn the Control encoder to adjust the parameters in finer increments.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE MIKRO - Manual - 830

Native Instruments Maschine MIKRO Specifications

General

Brand	Native Instruments
Model	Maschine MIKRO
Category	Telephone
Language	English