Adding Multiple Samples at Once
You can also drag several Samples to the Sample Map at once:
1. Hold [Ctrl] ([Cmd] on Mac OS X) or [Shift] on your computer keyboard and click the de-
sired Samples in the Browser or in your operating system.
2. Drag the selected Samples to the Sample Map.
→
This will create multiple adjacent Zones. The width (i.e. key range) of these Zones will
again depend on where they are dropped in the Sample Map: The higher you drop, the
wider each Zone will be. Dragging to the top part layers all Zones across the entire key-
board.
The placement of the Zones depends on the original Samples’ position in the selection list:
The first Sample selected will get the Zone with the lowest key range, the second Sample se-
lected will get the Zone just over the previous one, etc.
Adding a Sample to the Sample Map on the Controller
To add a new Sample to the Sample Map of the current Sound:
1. Press SAMPLING to enter Sampling mode and press NAV + pad 16 to open the ZONE
page.
2. Press F3 (ADD).
Your controller automatically switches to the Browser with the SAMPLE type preselected.
3. In the Browser, select the Sample you want to add to the map of the current Sound (see
↑3.2, Searching and Loading Files from the Library for more information on using the
Browser on your controller).
4. Press the Control encoder to load the Sample.
→
A new Zone is created that contains the added Sample. Your controller automatically
switches back to Sampling mode and the new Zone is selected and appears on the dis-
play, ready to be tweaked.
Sampling and Sample Mapping
Mapping Samples to Zones
MASCHINE MIKRO - Manual - 834
To Next Page
Loading...
