Oce PlotWave 360 - Changing Passwords for Authorised Users

Change the password for authorised users
When to do
For security reasons it is advised to periodically change the password of the three access
modes (Key operator, System administrator, Power user) in Océ Express WebTools.
Attention:
Handle and store all passwords securely and with care. In case of forgotten passwords, a
service technician can reset the passwords only when his rights have been enabled. Other-
wise the machine has to be reinstalled.
How to change the password for authorised users
In Océ Express WebTools:
1.
Open the 'Configuration' - 'Connectivity' tab.
2.
Click 'See all' in the 'Passwords' section.
3.
Select 'Key operator password', 'System administrator password', or 'Power user password'
depending on the password you want to change. A new window opens up.
4.
Log in as Key operator to change the key operator password. The default key operator
password is KeyOp.
Log in as System administrator to change the system administrator password. The default
system administrator password is SysAdm.
Log in as Power user to change all the passwords. The default power user password is
PowUsr.
Note:
The passwords are case sensitive. You can only use characters from the following range:
A-Z
a-z
0-9
_ - ~ ! ? @ # $ % ^ * + = , . : ; / | [ ] ( ) { }
You cannot use Chinese, Cyrillic, or Japanese characters.
5.
Enter the new password twice to confirm your input. The password is hidden.
6.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools126
Change the password for authorised users