Oce PlotWave 360 User Manual

Scan to an external location
Introduction
When you want to scan an original and you do not make any settings the default presets
are used. You only use the Smart Access to submit your job.
In the Smart Access you can select the location you want to sent your scan to.
With the Océ PlotWave 340/360 printer you can use the following external location
types:
•
'FTP'
•
'SMB'
•
'WebDAV' also called the cloud
•
'Eneo'
Before you begin
Before you can select the preferred location, you must create and configure the location
in Océ Express WebTools first. For more information on how to do this see ‘Create an
external location’ on page 153. Once you have created the locations in Océ Express
WebTools, they become visible in the Smart Access on the printer user panel.
Note:
When you do not create external locations in Océ Express WebTools, there is no other
location visible on the user panel than the public Smart Inbox.
Scan to an external location
1.
Feed the original face up and centred on the original feeding table.
Note:
You do not need to centre the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
Chapter 4 - Use the Printing System256
Scan to an external location

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches