EasyManuals Logo

Oce PlotWave 360 User Manual

Oce PlotWave 360
384 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #283 background imageLoading...
Page #283 background image
Move and re-adjust the printing system
Introduction
When you move the printing system to a new location, you must check if it needs re-
adjustment to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the
lower right front cover.
Required tool
Allen key
Key wrench
Attention:
When the printer is connected, you must first switch off and disconnect the printer (see
‘Switch off the printing system’ on page 280 and ‘Disconnect the network cable and the mains
supply cable’ on page 282).
Attention:
Close the media drawers.
Note:
Be aware of the size of the printer working area (see ‘Working area [Footprint]’ on page
25).
1.
Move the printing system to its new location.
Chapter 5 - Maintain the Printing System 283
Move and re-adjust the printing system

Table of Contents

Other manuals for Oce PlotWave 360

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oce PlotWave 360 and is the answer not in the manual?

Oce PlotWave 360 Specifications

General IconGeneral
Print TechnologyOcé Radiant Fusing technology
Resolution600 x 1200 dpi
Maximum Media Width36 inches
Print Speed6 A1/D prints per minute
Media Handling2 rolls
Warm-up TimeInstant On
Weight195 kg
Media WidthUp to 36 inches

Related product manuals