Set the 'Spool threshold'
Introduction
When the job memory is full the printer cannot receive new jobs, therefore it is necessary
to spool the memory. Set the 'Spool threshold' setting to define the spool capacity for
your jobs.
You can choose one of following values:
•
'Low'
Select this value when you have more small print jobs, and you want to allow a higher
capacity.
•
'Normal'
This is the default setting. Select this value when you have both small and large print
jobs.
•
'High'
Select this value when you have more large print jobs, and you want to reduce the risk
of having to abort the file transfer due to a full job memory.
Before you begin
For this procedure you need to log in as a Key operator.
How to set the Spool threshold
In Océ Express WebTools:
1.
Open the 'Preferences' - 'System defaults' tab.
2.
Click 'Edit' in the 'Printer properties' section, or click on the 'Spool threshold' setting.
3.
Select 'Low', 'Normal', or 'High'.
Select 'Low' when print productivity is an important factor.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools176
Set the 'Spool threshold'
To Next Page
Loading...
Need help?
General
