Configure the 'Media request time-out'
Introduction
The operator panel displays a message with a media request when the requested media is
not available on the printer.
•
When the 'Media request time-out' setting is disabled, the media request will be dis-
played on the operator panel until it is resolved.
•
When the 'Media request time-out' setting is enabled (default), you can enter a media
request time-out value in seconds. When the media request is not resolved within the
media request time-out period, the 'Action after media request time-out' setting deter-
mines whether the printer either deletes the job from the Jobs Queue or puts the job
in attention state.
When to do
Enable the 'Media request time-out' setting when your print productivity is an important
factor.
How to configure the 'Media request time-out'
In Océ Express WebTools:
1.
Open the 'Preferences' - 'System properties' tab.
2.
Click on 'Edit' in the 'Printer properties' section, or click on the 'Media request time-
out' setting.
3.
When you enable the setting, you must enter a time period as well. When you choose to
disable the setting, the time period will not be adjustable.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
How to configure the 'Action after media request time-out'
In Océ Express WebTools:
1.
Open the 'Preferences' - 'System properties' tab.
2.
Click on 'Edit' in the 'Printer properties' section, or click on the 'Action after media request
time-out' setting.
3.
Select 'Put the job on attention state' or 'Delete the job'.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools 161
Configure the 'Media request time-out'
To Next Page
Loading...
Need help?
General
