Oce PlotWave 360 User Manual

Configure the Automatic wake-up
Introduction
You can use Automatic wake-up to start up the printer automatically on each working
day. The wake-up time and working days are configurable.
How to configure the Automatic wake-up
1.
Open the 'Preferences' - 'System properties' tab.
2.
Click on 'Edit' in the 'Printer properties' section, or click on the 'Automatic on' setting.
3.
When you enable the setting, you must also enter the following settings in the 'Printer
properties' section: 'Start-up time', 'End of working day time', 'First working day' and
'Last working day'.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools 159
Configure the Automatic wake-up

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches