Oce PlotWave 360 User Manual

Set the 'Long plot mode'
Introduction
When the 'Long plot mode' setting is enabled, it allows you to print plots up to eight
times longer than when the setting is disabled.
For the printer to be able to print long prints, the print quality can be reduced.
Note:
For this procedure you need to log in as a Key operator.
Note:
The 'Long plot mode' setting does not apply for PDF or PostScript files.
How to set the 'Long plot mode'
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click 'Edit' in the 'General (non-postscript) rasterisation settings' section, or click on the
'Long plot mode' setting.
3.
Select the correct value. The setting is enabled when you check the box.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools174
Set the 'Long plot mode'

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches