Basic Scan Jobs - Default
Advised settings for scan jobs
Introduction
A default scan job takes three steps: feed the original face up, select the location in the
scan Smart Access, and tap the green button.
When you change the presets or the advanced settings it is called an extended scan job.
Advised settings for scan to greyscale or black and white file
It is best to predefine the advised settings for scan jobs you do most often.
In the table below you find the advised settings for specific scan-to-file jobs. In most
cases, the advised settings give the best results.
#
RemarksOriginal typeOriginal document
'Lines/text standard' or
'Folded lines/text'
Monochrome CAD
Drawings
For folded monochrome
originals apply 'Folded
lines/text'.
'Coloured original'Folded coloured CAD
drawing
The 'Coloured original'
mode converts all colours,
even weak ones, to
greyscale.
'Coloured original'Coloured original, like
CAD-colour, maps, busi-
ness graphics, etc.
'Coloured original'CAD drawings with marks
from marker pens
'Photo'Photos and high definition
colour prints
'Photo' gives a softer con-
trast than 'Coloured origi-
nal'.
For photos and colour
prints scan to greyscale is
preferred over scan to
black and white.
'Coloured original' or
'Photo'
Medium quality colour
prints
Chapter 4 - Use the Printing System248
Advised settings for scan jobs
To Next Page
Loading...
Need help?
General
