Oce PlotWave 360 - Load a Media Roll (Position 1)

Load a media roll (position 1)
Note:
When your printing system is equipped with an additional media roll, it is advised to
load an A0 or E-size media roll on position 1 and an A2 or C-size media roll on position
2.
Caution:
Watch your fingers when you handle the media roll.
How to load a media roll on position 1
1.
Pull firmly to open the media drawer.
2.
Place the new media roll on the roll loading station.
3.
Pull (1) the handle of the roll holder locking mechanism towards you.
Chapter 5 - Maintain the Printing System 299
Load a media roll (position 1)