Oce PlotWave 360 User Manual

Refill the Toner
Refill the toner
Introduction
When a ‘Refill toner’ message appears on the user panel, you need to refill the toner.
Note:
Make sure you use toner suitable for the PlotWave 340/360.
Note:
You must use only one bottle of toner at a time. When you use more than one bottle,
the compartment will flood and toner will spill.
Note:
When you have refilled the toner two consecutive times, you must also replace the
residual toner container. For more information, see ‘Replace the residual toner container’
on page 313.
Note:
You can leave the printer turned on when you refill the toner. You can even refill the
toner during the printing process without interrupting it.
Chapter 5 - Maintain the Printing System310
Refill the toner

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches