Oce PlotWave 360 User Manual

Set the 'Alignment' mode
Introduction
When you want shift the image on the sheet, you can change the alignment mode. With
the alignment mode you can also optimise the print productivity, as you reduce the dis-
tance the print carriage has to travel. You can, for instance, align the image to the top
right hand corner of the sheet.
You can choose the following alignment settings:
#
'Alignment' mode
'Top right''Top''Top left'
'Right''Centre''Left'
'Bottom right''Bottom''Bottom left'
Before you begin
For this procedure you need to log in as a Key operator.
How to set the alignment mode
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click 'Edit' in the 'Layout' section, or click on the 'Alignment' setting.
3.
Select the correct value.
Select 'Top right' when the print productivity is the most important factor.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools178
Set the 'Alignment' mode

Oce PlotWave 360 Specifications

General

Print Technology	Océ Radiant Fusing technology
Resolution	600 x 1200 dpi
Maximum Media Width	36 inches
Print Speed	6 A1/D prints per minute
Media Handling	2 rolls
Warm-up Time	Instant On
Weight	195 kg
Media Width	Up to 36 inches