Oce TCS400 - Page 26

26 Océ TCS400 User manual
The keys
The printer operator panel includes the following keys:
■ An on-line / off-line key
■ A stop key
■ Two upper softkeys
■ Two lower softkeys.
■ On-line / off-line key
Use the on-line / off-line key to switch between the on-line mode and the
off-line mode on the screen. If you press the on-line / off-line key while the
printer is active, the printer finishes the print. The printer then goes off-line.
The next section contains more information about the on-line mode and the
off-line mode (see ‘The on-line mode and the off-line mode’ on page 27).
■ Stop key
Use the stop key to delete or to stop a job (see ‘Delete or stop an active job
on the printer’ on page 153).
The function of a softkey depends on the mode of the printer operator panel.
(see ‘The on-line mode and the off-line mode’ on page 27)
Use the upper softkeys to perform the following:
■ Scroll through the information tabs on the on-line screen.
■ Scroll through the wizard cards on the off-line screen.
■ Step through the wizards on the off-line screen.
Use the lower softkeys to perform the following:
■ Select fields on the on-line screen
■ Select the wizards on the off-line screen
■ Select options in the wizards on the off-line screen.
Red attention LEDs
If operator action is required, the red error LEDs illuminate and you will hear
an audio signal. The printer displays the following types of signals:
■ An attention signal.
A short interrupted audio signal. The red LEDs flash two times.
■ A warning signal.
A short interrupted audio signal. The red LEDs remain illuminated
■ An error signal
A long, uninterrupted audio signal. The LEDs flash continuously.
Chapter 8 Error handling describes how to correct possible errors.