4-56
4-2 Function Mode
4
Functions
Basic Display
•Displays basic parameters.
•Below are the parameters displayed when this function is enabled.
Initial Screen Selection (Initial Screen at Power-ON)
You can select the Digital Operator screen to be displayed at power-on among the following items.
(By factory default, "01" (d001) is selected.)
Note: With "00" (screen on which the Enter key was last pressed) selected, if the last screen is other than d*** or
F***, the entrance (*---) of each group is displayed.
(Example) When the power is turned off and then on after a change in the A020 setting, "A---" is displayed.
No. Data Function name No. Data Function name
1 d001 to d104 Monitor display 16 A045 Output voltage gain
2 F001 Output frequency setting/monitor 17 A085 RUN mode selection
3 F002 Acceleration time 1 18 b001 Retry selection
4 F003 Deceleration time 1 19 b002
Allowable momentary power
interruption time
5F004
Operator rotation direction
selection
20 b008 Trip retry selection
6 A001 Frequency reference selection 21 b011 Trip retry wait time
7 A002 RUN command selection 22 b037 Display selection
8 A003 Base frequency 23 b083 Carrier frequency
9 A004 Maximum frequency 24 b084 Initialization selection
10 A005 O/OI selection 25 b130
Overvoltage protection function
selection during deceleration
11 A020 Multi-step speed reference 0 26 b131
Overvoltage protection level
during deceleration
12 A021 Multi-step speed reference 1 27 C021
Multi-function output terminal 11
selection
13 A022 Multi-step speed reference 2 28 C022
Multi-function output terminal 12
selection
14 A023 Multi-step speed reference 3 29 C036 Relay output (AL2, AL1) contact
15 A044 V/f characteristics selection
Related functions U001 to U012
Parameter No. Function name Data Default setting Unit
b038 Initial screen selection 000 to 202 001
To Next Page
Loading...
