3-9
3-4 Operation
3
Operation
4- Monitor-A Display Mode
1- Please select monitor mode A by using the or key at the
navigation layer. The cursor will be displayed in the Monitor-A pressing
the key.
2- After that, use the or key to select the function code to be
displayed into the Monitor-A.
Use or key to move the cursor to the function code (F001 in
this case) and use the or key to change the function code.
3- Use the key to access to the function code value. With the
or key the value can be changed. The changes will be stored
after pressing the key or cancelled pressing the key.
To Next Page
Loading...
